OH Consultant
Warehousing›SWMS

Reach Truck Operation SWMS

Reach trucks operate in narrow aisle configurations where clearances are minimal, load heights can exceed 10 metres, and tip-over risks are amplified by the reach mechanism extending the centre of gravity beyond the truck's wheelbase. Elevated load drops from reach truck operations can cause fatal crush injuries to workers below, and the narrow aisle environment limits escape routes for pedestrians. Reach truck operation requires an LF class high risk work licence, and operators must demonstrate competency specific to the reach truck type and maximum operating height. This SWMS template covers reach truck operation, stacking, and destacking with controls mapped to the Managing Risks of Plant code.

$35 AUDOne-time purchase · Editable DOCX · delivered within 24 hours

SWMS variants reference your state's WHS legislation. Instant download after payment.

Legal Requirements

regulation

WHS Regulation 2025 Part 5.2 — Plant; Part 5.3 — High Risk Plant

hrcw category

Work involving powered mobile plant (forklift — HRWL required)

code of practice

Managing Risks of Plant in the Workplace (binding July 2026 under Section 26A)

section 26a binding

Yes — Plant code binding July 2026. Non-compliance is admissible as evidence of breach.

hrwl required

Yes — LF class high risk work licence required

Hazards

HazardConsequenceLikelihood
Reach truck tip-over from overloading or excessive reach extension at heightOperator crush fatality, bystander crush injuriesUnlikely
Load drop from elevated height during stacking or destackingFatal crush injuries to persons belowPossible
Collision with racking uprights in narrow aisle configurationRacking damage, potential cascade collapsePossible
Pedestrian struck-by in narrow aisles with limited visibilityCrush injuries, entrapment between truck and rackingPossible
Whole-body vibration from extended reach truck operation on uneven floorsLower back pain, spinal disc degenerationPossible

Controls (Hierarchy of Controls)

Verify LF class HRWL and reach truck specific competency before permitting operation
Implement exclusion zones in active reach truck aisles — no pedestrian entry during operation
Enforce load capacity limits at each reach height as specified in the reach truck load chart
Install aisle-end barriers and warning lights activated when reach truck enters an aisle
Maintain floor surfaces to a flatness standard that prevents excessive vibration and instability
Conduct pre-operational checks covering mast, reach mechanism, forks, and safety devices daily
Install racking upright protectors in all narrow aisles to absorb minor contact impacts

Recent Prosecutions

Reach truck load drop fatality — Victoria$380,000

A warehouse worker was killed by a pallet falling from 8 metres during a reach truck destacking operation. The pallet had been improperly placed and the reach truck operator had not verified load stability before lifting. The aisle was not exclusion-controlled.

2023 — WorkSafe Victoria Prosecution Database

What Your SWMS Must Include

✓Reach truck load chart specifying maximum load at each height and reach extension
✓Aisle exclusion zone procedure preventing pedestrian entry during reach truck operation
✓Pre-operational check procedure covering mast, reach mechanism, forks, and seat belt
✓HRWL verification and reach-truck-specific competency assessment requirements
✓Load stability verification procedure before lifting pallets from or placing into elevated locations

Need a compliant Reach Truck SWMS?

Our WHS consultants develop reach truck SWMS with load charts, aisle exclusion procedures, and operator competency frameworks that satisfy regulator expectations.

Contact Us